4.6 (693) · € 624.00 · En stock
I have created artwork in Lightburn for engraving acrylic. I frame it perfectly on the spot, then when I start the image engraves 1/4 in off to the left WTH. I mean why would that happen? How can it frame correctly and then start engraving at some ransom position? Thank You Darren
XTool D1 Pro and Lightburn capatablity - LightBurn Software Questions - LightBurn Software Forum
Lightburn is Making my Xtool Engrave 1/2 above where it is supposed to - LightBurn Software Questions - LightBurn Software Forum
Xtool D1 Pro Rotary Stretching - xTool D1 - LightBurn Software Forum
Image shifts when engraving with Xtool D1 - LightBurn Hardware Compatibility - LightBurn Software Forum
xTool D1 Pro 20W Review - Mandala Art with a 20W laser engraver and cutter - CNX Software
Xtool D1 Pro IR laser tests - xTool D1 - LightBurn Software Forum
Xtool D1 Pro 20W and Lightburn 1.4 not emgraving images on RA2 - LightBurn Software Questions - LightBurn Software Forum
Need help - job produces upside down and backwards - Ortur Lasers - LightBurn Software Forum
Xtool D1 Pro 20W Laser is Firing During Travel - LightBurn Hardware Compatibility - LightBurn Software Forum
Engraving stays the same color - LightBurn Software Questions - LightBurn Software Forum
Xtool D1 Pro Rotary Stretching - xTool D1 - LightBurn Software Forum
Engraving stays the same color - LightBurn Software Questions - LightBurn Software Forum
xTool D Series - xTool Support Center
1064nm laser is producing poor and inconsistent results on metals - xTool D1 - LightBurn Software Forum